Lorenzo Mfg's Stabilizing Coulters are used to stabilize toolbar
side movement or draft on cultivators and other tillage
equipment allowing the bar to run "straight." Heavy
duty construction allows coulters to be run behind all types
of guidance systems.
- Double replaceable/Interchangeable spindles fit into
tubing from right or left, allowing frame to be mounted "where
The 8" wide and 4" deep mounting bracket is constructed
from 5/8" steel plate and is secured to the toolbar with
two fitted clamp caps. The 1-1/4 zinc plated Acme turnbuckle
has a threaded shaft with a ratchet handle. The Gauge Wheel arm
is constructed from 4 x 4 x 1/4" wall tubing and is extended
41" forward from toolbar to middle of spindle. The spindle
carrier tubing is 2-3/8" OD, 1/4" wall, with two 5/8"
set screws It has a 6 hole 3230 lb spindle and a 28" bevelled